Error code
Wolf electric cooktop error code E06
Wolf error code E06: a switching device is passing current when the control has told it to stop, on an electric cooktop, a sealed sheet of glass with the entire control under it. What the code covers, what to check first, and what it does not tell you — on cooktops & rangetops.
- From $95 diagnostic, credited to the repair
- 59 cities and neighborhoods covered
- OEM parts available on order
- In writing the price, before anything is opened
What we can confirm
Code E06, from the manufacturer's own documentation
A code is only meaningful together with the generation showing it — the same two digits mean different things across generations, and that is the commonest reason a code looked up online leads somewhere wrong. This one is recorded on CT electric cooktop.
The code
E06
A switching device is passing current when the control has told it to stop, on an electric cooktop, a sealed sheet of glass with the entire control under it
or call (305) 449-9681
What it narrows down to
Shorted sensors
What you are probably seeing
Diagnostic
From $95, credited to the repair
What it looks like from the kitchen
The symptom this code usually arrives with
A code names the subsystem; the symptom is what sent you to look at the display in the first place. That page says what it usually turns out to be, cheapest cause first.
-
One zone or all of them Cooktop not heating
An electric or induction cooktop with power and no heat. One zone out and the rest fine is a contained repair; all of them out is usually the supply or the control rather than the cooking surface.
- One zone cold, the rest working
- Every zone dead with the panel alive
- A code naming an element or a generator
On the same generation
What else belongs to the CT electric cooktop
A code belongs to a generation rather than to one cabinet. These are the other codes yours can show, and the models that can show this one — a display often has more than one thing to say, and the model number decides what any of it costs to put right.
Other codes this generation can display
Ambient temperature too high
Generator heat sink temperature too high
Open ambient thermistor
Model value change
Display board detected network error
No published cause
Keyboard calibration error
Keyboard error
The same two digits mean different things across generations. Search the full code list
In more detail
About Wolf electric cooktop error code E06
What this one means
A switching device is passing current when the control has told it to stop, on an electric cooktop, a sealed sheet of glass with the entire control under it. It is a code the manufacturer publishes for this appliance, not one we have worked out — and it is decoded here rather than left as three characters on a display.
What the code covers
A published cause names a circuit rather than a component, which is the single most useful thing to know before ordering a part. This one covers:
- A relay welded closed by years of switching a heavy load
- A triac that has failed short
- The element circuit that relay or triac feeds
- Shorted sensors
Worth doing before you call
- Take everything off the glass, including a cloth or a hot pan lid over the controls
- Switch the appliance off at the breaker if it is heating with nothing selected
Then what
A stuck relay is the one error in this archive that can heat with nothing asked of it, so it is a breaker-off condition rather than a wait-and-see one. The board carrying it is a replacement part.
This code is published for cooktops & rangetops. The full list of codes has the rest of them, searchable, including the labels older and newer machines use for the same conditions.
This article is based on:
- Official manufacturer documentation
- Internal repair procedures
- Technician repair history
- Company quality standards