Repair cost
Wolf burner & igniter repair cost
What it costs when a burner clicks and will not light — and the honest note that a real share of these end with a burner cap seated squarely and no part at all.
- From $95 diagnostic, credited to the repair
- 59 cities and neighborhoods covered
- OEM parts available on order
- In writing the price, before anything is opened
The short version
Where this figure comes from
A starting point for built-in appliances in South Florida, published so the number is not a mystery until somebody is standing in your kitchen.
Starts at
from $165
After a diagnostic from $95, which comes off the bill when you go ahead with the work.
or call (305) 449-9681
It is not
A quote for your unit
Exact cost
Confirmed after the on-site diagnostic
Warranty
On the labor we performed
What moves it
Why two of the same job cost different amounts
These apply at the same time and in both directions. Which of them is true of your kitchen is what the on-site diagnostic settles.
-
Whether a part is needed
A cap seated wrong and a clean is the visit. One igniter is the visit plus a part, and it is not an expensive one.
-
One burner or all of them
One is that burner. All of them is the spark module, the gas supply, or orifices wrong after a fuel conversion — and that last one is a longer job on a machine that has been wrong since it was installed.
-
Whether it is a rangetop
Reaching behind the manifold on a rangetop means lifting it out of the counter, which is time rather than parts.
The work itself
What we actually do
The job behind the figure: what it involves, when a symptom points at it, and what we check first.
-
from $165 Gas burner & igniter repair
A burner that clicks and never lights, lights and goes out, or burns yellow and sooty. On sealed burners this is a short list of causes and a real share of them cost the visit and nothing else.
- Cap seating checked before any part is named
- Igniter replaced per burner, not per cooktop
- Flame color and port blockage looked at properly
In more detail
About Wolf burner & igniter repair cost
The free half of this page
Lift the burner cap and set it back down squarely. That single step, at no cost, is the answer to a large share of burners that spark and never catch — and we would rather publish it than bill a visit for it.
Where the money goes when it is real
An igniter is an inexpensive part and it is replaced for the burner that has failed rather than as a set, because they age individually. What raises the figure is a machine where every burner is affected: that is the spark module, the supply pressure, or a conversion done wrong, and it takes measuring rather than swapping.
This article is based on:
- Official manufacturer documentation
- Internal repair procedures
- Technician repair history
- Company quality standards
Before you book
Questions about wolf burner & igniter repair cost
Do I need all the igniters done?
No, and we would say so if you did. They fail one at a time and there is no saving in changing four.
Every burner burns yellow.
Then look at the fuel conversion rather than the burners. A range fitted with orifices for the wrong gas does exactly this, and it has been that way since installation rather than failing.
Is it cheaper on a cooktop than a range?
Slightly, because there is less to move. The parts are the same and the diagnosis is the same.
Where we do it
Across Miami-Dade, Broward, and Palm Beach
Same terms everywhere we go: an on-site diagnostic first, the price agreed in writing, and the exact figure confirmed once we have seen the unit.
Neighborhoods people ask for by name