Error code
Wolf induction cooktop error code E07
Wolf error code E07: the control asked for heat and did not see the current that should have followed, on an induction cooktop, where the generator under each zone is a power supply in its own right and reports for itself. What the code covers, what to check first, and what it does not tell you — on cooktops & rangetops.
- From $95 diagnostic, credited to the repair
- 59 cities and neighborhoods covered
- OEM parts available on order
- In writing the price, before anything is opened
What we can confirm
Code E07, from the manufacturer's own documentation
A code is only meaningful together with the generation showing it — the same two digits mean different things across generations, and that is the commonest reason a code looked up online leads somewhere wrong. This one is recorded on Counter modules.
The code
E07
The control asked for heat and did not see the current that should have followed, on an induction cooktop, where the generator under each zone is a power supply in its own right and reports for itself
or call (305) 449-9681
What it narrows down to
Ambient thermistor on power board is open
What you are probably seeing
Diagnostic
From $95, credited to the repair
What it looks like from the kitchen
The symptom this code usually arrives with
A code names the subsystem; the symptom is what sent you to look at the display in the first place. That page says what it usually turns out to be, cheapest cause first.
-
One zone or all of them Cooktop not heating
An electric or induction cooktop with power and no heat. One zone out and the rest fine is a contained repair; all of them out is usually the supply or the control rather than the cooking surface.
- One zone cold, the rest working
- Every zone dead with the panel alive
- A code naming an element or a generator
On the same generation
What else belongs to the Counter modules
A code belongs to a generation rather than to one cabinet. These are the other codes yours can show, and the models that can show this one — a display often has more than one thing to say, and the model number decides what any of it costs to put right.
Other codes this generation can display
Data flash error
Invalid configuration
TC temperature too high
Controller options error
LIN communication error
No error
Appliance type is not valid
Main RTD is open
Main RTD is shorted
RTD port pins shorted
The same two digits mean different things across generations. Search the full code list
In more detail
About Wolf induction cooktop error code E07
What this one means
The control asked for heat and did not see the current that should have followed, on an induction cooktop, where the generator under each zone is a power supply in its own right and reports for itself. It is a code the manufacturer publishes for this appliance, not one we have worked out — and it is decoded here rather than left as three characters on a display.
What the code covers
A published cause names a circuit rather than a component, which is the single most useful thing to know before ordering a part. This one covers:
- The element itself, open somewhere along its length
- The relay or the wiring feeding it
- A thermal cutout that has opened and not reset
- Ambient thermistor on power board is open
Worth doing before you call
- Note whether one zone is affected or all of them — each has its own generator
- Note whether the oven still heats on other modes — bake, broil and convection use different elements
Then what
Naming the circuit is what this code does, and it is the useful part: it says which element to test before anything is ordered. Testing it means the back panel off, with the supply isolated.
This code is published for cooktops & rangetops. The full list of codes has the rest of them, searchable, including the labels older and newer machines use for the same conditions.
This article is based on:
- Official manufacturer documentation
- Internal repair procedures
- Technician repair history
- Company quality standards