--- title: "Burner & igniter repair cost" description: "Wolf burner & igniter repair cost: what it costs when a burner clicks and will not light — and the honest note that a real share of these end with" url: "https://wolfmiami.support/repair-cost/gas-burner-and-igniter-repair/" date_modified: "2026-08-20" --- # Wolf burner & igniter repair cost ### The free half of this page Lift the burner cap and set it back down squarely. That single step, at no cost, is the answer to a large share of burners that spark and never catch — and we would rather publish it than bill a visit for it. ### Where the money goes when it is real An igniter is an inexpensive part and it is replaced for the burner that has failed rather than as a set, because they age individually. What raises the figure is a machine where every burner is affected: that is the spark module, the supply pressure, or a conversion done wrong, and it takes measuring rather than swapping. What moves this figure National range for igniters: $150–$400 The cap is free to check and it is often the answer Igniters are replaced per burner, not as a set Whether a part is needed A cap seated wrong and a clean is the visit. One igniter is the visit plus a part, and it is not an expensive one. One burner or all of them One is that burner. All of them is the spark module, the gas supply, or orifices wrong after a fuel conversion — and that last one is a longer job on a machine that has been wrong since it was installed. Whether it is a rangetop Reaching behind the manifold on a rangetop means lifting it out of the counter, which is time rather than parts. The free half of this page Lift the burner cap and set it back down squarely. That single step, at no cost, is the answer to a large share of burners that spark and never catch — and we would rather publish it than bill a visit for it. Where the money goes when it is real An igniter is an inexpensive part and it is replaced for the burner that has failed rather than as a set, because they age individually. What raises the figure is a machine where every burner is affected: that is the spark module, the supply pressure, or a conversion done wrong, and it takes measuring rather than swapping. --- **[Read full article: Burner & igniter repair cost](https://wolfmiami.support/repair-cost/gas-burner-and-igniter-repair/)**