---
title: "Wolf built-in oven error code 07"
description: "Wolf built-in oven error code 07: wolf error code 07: the control asked for heat and did not see the current that should have followed, on a built-in oven…"
url: "https://wolfmiami.support/error-codes/error-code-07-wall-oven/"
date_modified: "2026-08-20"
Product line: "E Series legacy"
---


# Wolf built-in oven error code 07

### What this one means

The control asked for heat and did not see the current that should have followed, on a built-in oven, where every part named here sits behind trim that is screwed into the cabinetry rather than behind a panel that slides out. It is a code the manufacturer publishes for this appliance, not one we have worked out — and it is decoded here rather than left as three characters on a display.

### What the code covers

A published cause names a circuit rather than a component, which is the single most useful thing to know before ordering a part. This one covers:

- The element itself, open somewhere along its length
- The relay or the wiring feeding it
- A thermal cutout that has opened and not reset
- DLB2 relay open
- DLB1 relay is open, relay failed, or connection is loose
- Thermal cutout failed, open, or connection is loose
- Oven controls overheated

### Worth doing before you call

- Note which cavity it is on a double oven — the code says upper or lower and that is half the diagnosis
- Note whether the oven still heats on other modes — bake, broil and convection use different elements

### Then what

Naming the circuit is what this code does, and it is the useful part: it says which element to test before anything is ordered. Testing it means the back panel off, with the supply isolated.

This code is published for built-in ovens & steam ovens. The [full list of codes](https://wolfmiami.support/error-codes/) has the rest of them, searchable, including the labels older and newer machines use for the same conditions.

Built-in ovens & steam ovens

What this code means

What this one means

The control asked for heat and did not see the current that should have followed, on a built-in oven, where every part named here sits behind trim that is screwed into the cabinetry rather than behind a panel that slides out. It is a code the manufacturer publishes for this appliance, not one we have worked out — and it is decoded here rather than left as three characters on a display.

What the code covers

A published cause names a circuit rather than a component, which is the single most useful thing to know before ordering a part. This one covers:

The element itself, open somewhere along its length

The relay or the wiring feeding it

A thermal cutout that has opened and not reset

DLB2 relay open

DLB1 relay is open, relay failed, or connection is loose

Thermal cutout failed, open, or connection is loose

Oven controls overheated

Worth doing before you call

Note which cavity it is on a double oven — the code says upper or lower and that is half the diagnosis

Note whether the oven still heats on other modes — bake, broil and convection use different elements

Then what

Naming the circuit is what this code does, and it is the useful part: it says which element to test before anything is ordered. Testing it means the back panel off, with the supply isolated.

This code is published for built-in ovens & steam ovens. The full list of codes has the rest of them, searchable, including the labels older and newer machines use for the same conditions.

---

**[Read full article: Wolf built-in oven error code 07](https://wolfmiami.support/error-codes/error-code-07-wall-oven/)**